I’ve left the the Spaghetti Monster to gather dust for a few months now. I’ve been having trouble getting prints to stick to the bed
Category: 3D Printing
Taming the Z-offset on my Tronxy X5SA-600
I’ve struggled to get a decent first layer on a consistent basis and I’ve never truly been able to adjust the Z-offset to my satisfaction.
Klipper Upgrade Hasn’t Been A Smooth Run
It’s been a little over a month now since I got Klipper up and running and while I did manage to initially get a few good prints, it’s now been several weeks since I’ve been able to complete a print from end-to-end.
Tronxy X5SA-600 Klipper Conversion Part 5 – The New Dawn Bit – Printing Calibration Parts
Calibration and tuning Klipper to work with my Octopus Pro converted Tronxy X5SA-600
Tronxy X5SA-600 Klipper Conversion Part 4 – The Moment Of Truth Bit – Turning It On And Installing Firmware
Installing Klipper on my Tronxy X5SA-600 with an Octopus Pro motherboard and starting it up.
Tronxy X5SA-600 Klipper Conversion Part 3 – The Anxious Bit – Octopus Pro Hookup
In this third instalment of my Tronxy Klipper conversion, I’m going to cover how I went about hooking everything up to the Octopus Pro motherboard
Tronxy X5SA-600 Klipper Conversion Part 2 – The Scary Bit – Rewiring
Extending the wiring loom on a Tronxy X5SA-600
Tronxy x5SA-600 Klipper Conversion Part 1 – The Exciting Bit – Buying Parts
Tronxy X5SA-600 BTT Octopus Pro and Klipper upgrade.
I Bought a 3D Printer to Make NLA Car Parts
In November 2021, I decided it would be cool to have a 3D printer to make parts that a no longer available (NLA). I really had no previous interest in 3D printing and no knowledge on the subject.